White and Burgundy Bouquet Shell: Aligning a Lace-Like Overlay

Empty white bouquet shell with a pointed burgundy centre, pale lace-like floral overlay and red-and-white ribbon at the handle.

A pointed burgundy panel sits inside a white border, with pale floral shapes crossing its lower area. The burgundy remains visible between the flowers of the lace-like overlay. Watch the layers being aligned on the table before they are gathered into an empty bouquet shell, then compare the border and pattern in the finished upright view.

Open the original Reel on Instagram

0:03–0:15 · Compare the burgundy panel with the white backing

The presenter trims a white sheet, lays burgundy paper over it and cuts the inner panel to leave a visible white margin. The pieces are checked together while flat. In the final shell, that margin forms a light outline around the high burgundy point.

For your own sample, place the two colours together before joining them. Compare the white edge along each side of the point and mark the outline you want to retain. Size the pieces against your prepared form; the video supplies no measured template.

0:15–0:24 · Position the floral overlay while the panel is flat

The white and burgundy panels are joined, and the separate floral overlay is brought across them. Its scalloped upper edge sits below the top point, leaving a broad burgundy area above the pale pattern. The layer is then fitted against the prepared base.

Compare the pattern on your own backing before gathering it. Check how much of the darker colour shows between the floral shapes and where the scalloped edge crosses the panel. The source establishes a lace-like appearance; it does not identify the overlay’s fibre or exact material specification.

0:24–0:30 · Check the layers again after gathering

The layered panel is brought around a base that already has short pale inner folds and a covered lower section. The paper curves inward at the sides and gathers below. The tall burgundy point and floral overlay remain visible behind the shorter lining.

Lift your sample to its intended display angle after this gather. Compare the white border with its earlier flat outline and check that the floral pattern still reads across the curved surface. Adjust the visible overlap before settling the lower wrap.

0:30–0:45 · Add white outer sheets and review the finish

Further white pieces are cut and fitted around the sides and front, followed by the handle covering. Their raised corners sit outside the burgundy centre, while the lower front curves beneath the floral overlay.

The closing reference shows red and white ribbon and a small decorative tag. Bow tying and preparation of the internal base are not demonstrated. When planning your version, compare the outer front height with the overlay so the patterned area remains visible above it.

Request the backing and overlay as separate samples

Describe the white and burgundy shades, intended shell size and desired border width. For the overlay, include the floral pattern, scalloped edge and how much backing colour you want to show through. Confirm composition and handling on actual samples.

Ask about wrapping and floral overlay options

Choose “Other”. The optional note below can be copied into your inquiry.

Copy an optional overlay materials inquiry

White and Burgundy Bouquet Shell: Aligning a Lace-Like Overlay. https://fafaflower.com/white-burgundy-shell-lace-like-overlay/ White backing, burgundy inner paper, a pale floral overlay and red/white ribbon for our own shell. Shell and sheet sizes, shades and border width: [details]. Overlay pattern, edge and desired show-through: [details]. Ribbon widths, quantity and destination: [details]. Please confirm available materials, specifications, pack sizes and samples.

Reference demonstration: 眼镜花艺资材. Wrapping observations by FAFAFLOWER.